Advertising Carriers            Return to Home Page   More below!

MODEL 541717FM     A new entry to our website, this Fluorescent Lighted Ad Carrier has a very light electrical load, yet carries a bright surface for maximum exposure. It can be fitted with markers both front and back, to conform to your local regulations or your tastes. It is a sturdy yet light weight carrier with attractive features and long life expectancy.


AC541717FM



Three Sizes of THIS shape available.
- - - - - 

Also Available in Three-sided Triangular Signs
Triangular Roof Signs


   Screw-down Mount Bracket.  

(Also available with Magnet and Strap mounting for No-Holes attachment. 
See Below. 

   Available 54", 42"  and 39" lengths. (173cm, 106cm and 99 cm respectively). These carriers fit comfortably on all vehicle roofs. Measure the distance from your windscreen top to the top of the rear window. Allow a few inches in front and back of your carrier to determine which will fit your car or van best. On MOST vehicles, all of them can be used. We recommend permanently screwing these units to the vehicle roof. There IS a magnet and strap kit available (see below) for any of these carriers. You MUST use BOTH magnet and strap for safety reasons if you choose this system.. These units have been used in desert heat, arctic snow, ocean salt air and gulf breezes. You cannot buy better. 

Carrier has a molded one piece cover with an aluminum floor. The floor is attached to the vehicle with four mount brackets ( shown above). A carriage bolt is mounted from the bottom of the "bridge" of the mount, and bolted to the floor. Four tech screws or pop rivets hold each foot securely to the roof of the car.  A rubber skirt is fitted top the edges of the shell to protect the wiring and assembly under the ad carrier. A waterproof entry to the car provides power to the fluorescent lamp and ballast inside the carrier. The shell is made of materials which resist discoloration with age from sunshine or moisture.
Priced from $495.00, $475.00 and $455.00 respectively. Call us 760-345-4347 for exact prices, details on marker add-ons, shipping estimates and art work.  It usually is more cost effective to have vinyl signage made locally. You retain final decisions on colors and design more readily if you have it done near home. Overseas and foreign orders, be sure to contact us for shipping and restrictions. Overseas orders will not be accepted without a telephone call or e-mail exchange.         

3/1/08 Pricing: 54"(AC541717FM)  Largest $495.00  +shipping $125.00

Click to purchase one 54" sign   $495.00 +ship    For quantity purchases, be sure to call or e-mail for a quote

3/1/08 Pricing: 42"(AC421717FM) Intermediate $475.00 +shipping $108.00

Click to purchase one 42" sign  $475.00 +ship    For quantity purchases, be sure to call or e-mail for a quote

3/1/08 Pricing: 39"(AC391717FM) Smaller $455.00 +shipping $98.00

Click to purchase one 39" sign  $455.00 +ship    For quantity purchases, be sure to call or e-mail for a quote
 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Prefer a TRIANGULAR CARRIER three-sided carrier instead?   Click here>>> Triangular Roof Signs <--TOP QUALITY! - CHECK 'EM OUT!
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -  - - - - - - - - - - - - - - - - - - - - - - - - - - - - -


Add a Magnet & Strap mount to your carrier: no drilling roof!
 Available for AC541717FM,  AC421717FM or AC391717FM ad carriers, or the Triangular carriers on the next page> Triangular Roof Signs!

This adds 4 strong 3" cup magnets AND four high quality ratchet straps to mount to door edge.  There is a screw-security provision for use if you choose (see diagram) .


                                             
 
Click to purchase one or more 4-strap kit  $75.00 (If buying ad carrier at same time, kit is installed by factory before shipping.

REPLACEMENT BALLASTS FOR AD CARRIERS

 This ballast is designed to handle one fluorescent lamp in your ad carrier with any of the following numbers printed on the lamp;

F13TS, F14TS, F15TS, F17TS, F32TS,
F15T12, F20T12, F30T12, F34T12, F40T12
 

Part Number FB2D12-132  $45.00 + shipping $4.95 each

These ballast units are used by many manufacturers as original equipment and have been used in the field in desert heat and arctic cold. They are easily mounted, often in the original bolts in your carrier's floor.

Click to purchase one replacement ballast  ($45.00 + shipping of $4.95 each)

  Here's a different approach...

  38" across x 11-1/4" front to back, 9-1/2" High

Our Model FSD-38 is a cross between a toplight and an advertising carrier, and can be used for either.
It is made of the same tough plastic as your traditional toplight, but has a considerably wider face
allowing you to place advertising on both sides, and set it front to back on your vehicle.
It also makes a good student driver sign, as you can see! There is even enough room below the driving
school line to add a city and phone number. Call or E-Mail us regarding colors, descriptions of text and
shipping costs. 760-345-4347. Quantity pricing is available.

$99.95 as a permanent screwbase light, or $149.95 as a magnetic mounted removable sign*.

Click here to order one FSD-38 for direct mounting to your vehicle. 99.95
Click here to order one FSD-38-Mag for magnetic attachment to your roof*. 149.95
*We caution you about winds -  with a large surface area,  a magnetic mounted sign can be blown off
your car by nature or even a passing truck. If you are traveling 70 and the opposing truck is
traveling 70, that's 140 MPH wind gusts!  Consider, please!, permanently mounting the sign. 

Use this button to view your cart and finalize the purchase.  THANKS !

HOME PAGE     More Roof AD CARRIERS               

Triangular Roof Signs <--TOP QUALITY! - CHECK 'EM OUT!